6
SEATBACK POSITIONING
1. The front seat has a two position recline. To recline the seat, rotate the
reclinebarandpressbackwardontheseatback.Pleaseseegure13.To
place the seat in the upright position, press upward on the seat back while
rotating the recline bar.
2. The upright position should be used only for a child that is at least 6
months old. Note: Seat does not fully recline.
3. To recline the rear seat locate the plastic adjuster and squeeze the ends.
Loosenortightenthestraptoyourdesiredreclineposition.Pleasesee
gure14.
TO RECLINE SEATS
TO REMOVE REAR SEAT
1. Removethe rearcanopy. Locatethe rearseat attachmentpositions.
Pleaseseegure15.Unhookthefabricfromthetabsonthestroller
handle frame. Repeat for opposite side. Also un snap the footrest fabric
as shown ingure 15A.To completely removerear seat fabric you
must unhook the D-Ring from the rear jump seat, and you must remove
the 2 D-Rings from the rear seat. Please See Figures 15B and 15C.
2. To remove the lower portion of the rear seat fabric, locate the two
attachment positions. Please See Figure 16. Unhook the fabric from
the tab on the lower frame tube, next release the front snap located on
the same lower frame tube.
3.Whenyouarenotusingthejumpseatharnessplaceitinthestorage
location on the rear of the front seat. Please See Figure 16A.
Fig. 13.
Fig.14.
Fig.15.
Fig.16.
6
Fig.15.A
Fig.15.B
Fig.15.C
Fig.16A.