Filter
Top Products
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
ASSEMBLY
IMPORTANT! To ensure safe operation of your stroller,
please follow these instructions carefully. Please keep these
instructions for future reference.
IMPORTANT! Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or sharp
edges. NEVER use if any parts are mssing or broken.
IMPORTANT! Adult assembly is required.
ASSEMBLY
3
4
Remove stroller from box. The front wheels,
rear wheels, child tray, and parent tray MUST be
installed prior to use.
FRONT WHEELS
To attach the front wheels, unfold stroller as
described in the section following:
• Unlock the red release lever.
• Unfold stroller frame by pulling backward
on the stroller handle (Fig. 1)
To attach the front wheels, lean the stroller back
so that it rests on the handle with the front and
rear legs pointing upward. Position the front
wheels over the front leg tubes so that the hole in
the housing lines up and will slide onto the legs.
(Fig. 2) Firmly push down until the wheels lock
securely into place. Tug on each wheel to ensure
they are both securely attached.
REAR WHEELS
Position rear axle over the rear leg tubes, brake
pedals facing the back. At the same time, push
down applying equal pressure to both sides until
they lock into place. (Fig. 3)
Note: NEVER use stroller if wheels do not lock into
place. If you need assistance, please contact our
customer service department at 1-800-328-7363,
M-F, between 8am and 4:30pm, PST.
FOOT REST
Push downward on the foot rest until it snaps onto
the U-shaped frame cross member. (Fig. 4)
PARENT TRAY
To attach the parent tray, position the tray so that
the hinges for the storage compartment are facing
foward. Snap the parent tray to the stand at the
top of the frame. Check that the tray is securely
latched in place. (Fig. 5)
CHILD TRAY
To attach the child tray:
Push the tray downward and onto each side of the
front armrests until both side snaps into place.
(Fig. 6) Check that tray is securely latched in
place. Repeat the above step for the rear child tray.
WARNING:
The child’s tray
is not a restraint device: always secure
your child with the seat belt. DO NOT
lift the stroller by the child’s tray. Use
care when attaching the child’s tray on
the stroller with a child in the stroller.
To access the child seat:
Pull one side of the release lever (Fig. 7) located
on the underside of the child tray and lift upward.
Either side of the child tray will lift and rotate out
of the way to allow access to the front and rear
seats. (Fig. 8)
To rotate the child tray:
In order to attach an infant car seat to the stroller,
Fig. 3
Fig. 2
red release
lever
Fig. 1
Fig. 4
Fig. 5
Fig. 6
release lever
Fig. 8
Fig. 7
Snap On
Push Down