Filter
Top Products
1
2
Rear Axle
Stroller
Front Wheels (x2)
PARTS
ASSEMBLING
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE
INSTRU
CTIONS CAREFULLY AND RETAIN THEM FOR FUTURE REFERENCE.
ASSEMBLY:
1. Remove stroller from box. NOTE: The front wheels, rear wheels, parent tray, and support bars specific to
your infant car seats need to be installed prior to use.
2. To attach the front wheels, unfold stroller and lean backwards so that it rests on the handle and rear frame
tubes with the front wheel tubes po
inting upward. (Fig. 1) Position the front wheel assembly over the front tube
so that the large hole in t
he swivel assembly will slide onto the front tube. Carefully push the wheel assembly
until it lo
cks onto the front leg. Tug on the wheel assembly to ensure that it is securely attached to the stroller.
(Fig. 2)
3. Lean the stroller forward to rest on the front wheels. To attach the rear wheels, position the rear axle and
wheel assembly so that the brake levers are facing the rear of the stroller. (Fig. 3.1) Press the rear wheel
asse
mbly onto the rear frame tubes, being careful that the push buttons on the forward side of each rear tube
engage the hole on the forward side of each rear wheel housing. (Fig. 3.2) Tug on the rear wheel asse
mbly to
ensure that it is securel
y attached to the stroller and firmly locked into place.
DO NOT use the stroller if the wh
eels are not locked into place, but rather contact our customer service
department immediately at (800) 328-7363, between the hours of 8:00am and 4:30pm PST, for assistance.
Fig. 2
Fig. 1
Fig. 3
Push onto
bayonet
Line up the frame tubes
with theaxleassembly
slide onto frame tubes
at the same time
3
4
Push down until axle
housing snaps into place
Axle housing is secure when
the metal tab locks axle
housing into place
1” Bar (x 2)Flat Bar
3
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.