Filter
Top Products
5
4
BATTERY INFORMATION
1. The AC Adaptor (5) supplied with this product is only designed to
charge the included NiMH rechargeable battery (6). Do NOT use
this AC Adaptor (5) for other purposes except to charge the
included NiMH battery (6).
2. The Rechargeable AA Battery Holder (9) is included to allow the
consumer the option of using high capacity, rechargeable AA
batteries ONLY. Do not use dispos
able alkaline batteries. We
recommend the use of 1600mA or larger AA batteries for best
performance and longest run time. Always use the same current
capacity in all 8 batteries placed in the rechargeable battery holder
(9) - do not mix capacities (i.e.: don't use 2000mA and 1600mA
together). Do NOT use the included AC Adaptor (5) to charge
batteries while in this holder.
3. The transmitter requi
res a separate, 9V battery for operation. Any
9V battery will function well in the transmitter, including disposable
alkaline batteries. It is recommended that the batteries be
disconnected from the boat, and removed from the transmitter
when not in use.
4. This product uses 2 powerful motors to provide enough thrust for
fishing. During periods of continuous operation (more than 1 or 2
minutes of c
ontinuous power), the batteries can become warm.
This is normal, and does not indicate a malfunction of the product.
5. When the batteries are depleted to the point they need to be
charged, allow the rechargeable battery (6) to cool first before
being removed from the boat and charged. Warm or hot batteries
should always be allowed to cool before recharging.
6. Always dispose of used batteries proper
ly. Never dispose of
batteries of any kind in fire. See local and state regulations for
disposal of NiMH batteries.
11. Once you see your bobber go under, steer the AVIVA Fishin’ Buddy
back to the operator. Once it’s within reaching distance, hook the
Retrieving Hook (8) under the bar and lift to land the fish.
NOTE: Do not allow Antenna to touch the water. This will cause the unit
to malfunction.
ASSEMBLY
UNIT SHOULD ONLY BE ASSEMBLED BY AN ADULT.
1. Charge your boat’s battery by connecting the Ni-MH rechargeable
battery (6) to A/C Adaptor (5) and plug into a 110 volt wall outlet.
2. Allow battery to charge for a full 8 hours before first use.
3. Remove red cap by twisting a ¼ turn. Insert 9-volt Battery (4) into
Remote Control (2). Replace red cap by twisting a ¼ turn.
4. Carefully screw the tele
scoping antenna into hole on the top of the
remote control.
5. Feed antenna wire on boat through Clear Plastic Sleeve (7) and
loosely knot at the end. Clear Plastic Sleeve (7) with antenna wire
must be in the upright position to work properly.
6. Once fully charged, unclip battery (6) from A/C Adaptor (5) and clip
to the battery clip located under the back seat of the boat. Insert
rechargeable bat
tery (6), replace cover and secure.
7. Turn remote control on at the switch. Turn the boat on with the
button located on the bow and extend the remote’s antenna.
8. Test the boat with the propeller’s pointed away from you, and other
people, before placing in water.
9. Inside the accessory packet you will find 2 pre-assembled fishing
lines (3). Clip end of line to eyelet located at the rear of the boat.
10
. Always have adult supervision while baiting your hook. Once hook
is baited, lower your boat into the water using the Retrieving Hook
(8) and steer your boat towards the fish.