Filter
Top Products
2. AVENT ISIS Breast Pump parts
PUMP
a) Funnel cover
b) Let-down massage cushion
c) Pump cover
d) Silicone diaphragm
and stem*
e) Handle
f) Pump body and funnel
g) White valve*
3. To clean and sterilise your pump
Before you use your breast pump for the first
time and every time before use:
Separate all parts, then wash in the dishwasher
or in warm soapy water and rinse. Do not use
antibacterial cleaners/detergents. Sterilise in an
AVENT Steam Steriliser (electric or
microwave), or by boiling
for 10 minutes or in a chemical sterilising
solution, following the manufacturer’s
guidelines. If using an AVENT Steam Steriliser,
the pump will remain sterile in the Steriliser
for 3 hours provided the lid is not removed.
4. To keep your pump sterile and
compact for travel
After sterilising all parts, you can clip the cover (a) over
the funnel and let-down massage cushion and screw
the travel cover (m) onto the pump body (f) in place
of the bottle or bottle holder.
UKUK
5. Using the AVENT Disposable System
with your ISIS Breast Pump
Simply replace the reusable AVENT bottle with
the AVENT Disposable Bottle Holder fitted with
a disposable bottle bag.
6. How to assemble your AVENT
ISIS Breast Pump
Separate all parts and ensure pump has been cleaned and sterilised
as in section 3:
1 Wash your hands thoroughly. Click the white valve (g) into the
pump body (f) from underneath making sure the flat side of the
valve is downwards.
2 Place the pump body (f) onto the bottle (h).
3 Twist gently clockwise until it ‘clicks’in place.
DO NOT OVERTIGHTEN
4 Place the silicone diaphragm and stem (d) into the pump body (f).
Make sure it fits securely round the rim by pressing down with your
fingers to ensure a perfect seal. (This is easier if assembled whilst wet.)
5 Place the forked end of the handle (e) under the diaphragm
stem (d) and push down gently on the handle until it clicks
into place.
6 Carefully insert the let-down massage cushion (b) into the pump
funnel (f) making sure it is perfectly sealed all round the rim of the
funnel. (This is easier if assembled whilst wet.)
7 Click the pump cover (c) onto the pump body (f). To make the pump
completely stable insert the bottle into the stand (i).
7. When to use your AVENT ISIS Breast Pump
1 If possible, wait until your milk supply and breastfeeding schedule are
well established, normally at least 2-4 weeks after birth, unless told
otherwise by your doctor or breastfeeding adviser
BOTTLE
h) Reusable bottle (125ml/4oz)
or Disposable Bottle System
i) Stand
j) Dome cap
k) Newborn teat (0m+)
l) Screw ring
m) Travel cover
n) Sealing disc
*spares included
32