Filter
Top Products
52
OWNER’S MANUAL
C.10 Secure the interior mounting plate assembly to the interior
wall by threading the Phillips screws into the four toggles.
C.11 Take one end of the eight foot length of 3/4" (1.9 cm) I.D.
clear braided PVC tubing and slip one of the stainless steel hose
clamps over the end. Next, push the tubing as far as it will go
onto the 90 degree hose barb connector on the back of the cabinet.
Then secure the PVC hose by tightening the stainless hose clamp
with a flat blade screw driver.
C.12 Move the sterilizer into its permanent location and then
stretch the clear braided PVC tubing up to the 90 degree wall
mount fitting. Allow for an extra inch or two and cut to length.
Slip a stainless steel hose clamp over the tubing and then push the
tubing as far as it will go onto the 90 degree hose barb connector.
Secure the PVC tubing with the second stainless steel hose clamp.
C.13 Exterior Wall Mounting: Slide the exterior mounting plate
over the black PVC tubing that extends out through the 2” hole
and then mark the four mounting holes.
C.9 Insert the black hose that is attached to the interior plate
assembly into the two inch hole and line up the four mounting
holes with the four toggles.
The gray interlock button on the fitting should be facing up.
© Andersen Products Ltd