Filter
Top Products
3M Packaging Systems Division
Installation Instructions
Equipment Warranty and Limited Remedy: THE FOLLOWING WARRANTY IS MADE IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY, THE IMPLIED
WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND ANY IMPLIED WARRANTY ARISING OUT OF A COURSE OF
DEALING, A CUSTOM OR USAGE OF TRADE:
3M warrants that its 3M-Matic
TM
P/N 78-8069-3983-7 Caster Kit Attachment will be free from defects for ninety (90) days after delivery. If
any part is proved to be defective within the warranty period, then the exclusive remedy and 3Ms and sellers sole obligation shall be, at
3Ms option, to repair or replace the part, provided the defective part is returned immediately to 3Ms factory or an authorized service
station designated by 3M. A part will be presumed to have become defective after the warranty period unless the part is received or 3M is
notified of the problem no later than five (5) calendar days after the warranty period. If 3M is unable to repair or replace the part within a
reasonable time, then 3M, at its option, will replace the equipment or refund the purchase price. 3M shall have no obligation to provide or
pay for the labor required to install the repaired or replacement part. 3M shall have no obligation to repair or replace (1) those parts failing
due to operator misuse, carelessness, or due to any accidental cause other than equipment failure, or (2) parts failing due to non-
lubrication, inadequate cleaning, improper operating environment, improper utilities or operator error.
Limitation of Liability: 3M and seller shall not be liable for direct, indirect, special, incidental or consequential damages based upon
breach of warranty, breach of contract, negligence, strict liability or any other legal theory.
The foregoing Equipment Warranty and Limited Remedy and Limitation of Liability may be changed only by a written agreement signed by
authorized officers of 3M and seller.
WARNING Turn "Off" electrical power
and disconnect air supply to the machine
before beginning installation. Failure to do so
could result in injury to personnel or damage to
the machine.
Refer to figure 1 and follow the instructions below to
install the casters.
1. Use appropriate material handling equipment
and blocking techniques to raise case sealer so
the base is a minimum of 6 inches or 150 mm
above the floor. Remove and discard the four
leveling pad feet (A), screws (B), washers (C),
and nuts (D).
Maintenance
Lubrication The wheel bearing and swivel bearing require lubrication periodically. Lubricate twice a year with
multipurpose grease.
Operating Instructions
1. After positioning the case sealer in the desired
location, the casters can be locked by pushing
down on the brake lever shown in Figure 1.
2. The casters are unlocked by lifting the brake
lever up to allow movement of the case sealer.
Figure 1 Caster Installation and Parts Illustration
3M Center, Building 220-8W-01
St. Paul, MN 55144-1000
3M-Matic is a trademark of 3M,
St. Paul, Minnesota 55144-1000
Litho U.S.A.
© 3M 1999 34-7004-7494-2(F59.0)
5. Remove the support blocks and allow the case
sealer to rest on the four casters to complete
the installation.
2. Insert threaded caster stud into case sealer leg.
Note: On 100a machine the caster stud screws
into case sealer leg.
3. Place lockwasher (2) and nut (3) on the caster
stud and tighten the nut to secure the caster.
4. Follow steps 2 and 3 above on all four legs.
5. Remove the support blocks and allow the case
sealer to rest on the four casters to complete
the installation.
CAUTION Refer to case sealer
instruction manual for weight of case
sealer.
3