Moxa Technologies RS-485 Musical Toy Instrument User Manual


 
Hardware Installation
Industio CI-134 Series User’s Manual 2-3
CAP jumper JP1. The software and hardware configuration will be completed at the
same time while doing the software configuration, detailed in the next chapter. Of
course, the method is valid only under the previously described circumstances.
Besides, the speed range will be set to
from 50 to 921.6K bps by default, which is
called
High Speed Spectrum and detailed in section "Hardware Installation with
IO-IRQ Utility".
How to Do Quick Hardware Installation
1. Short the jumper JP1 on the upper-left corner of the board.
2. Plug the board in PC with the desired system installed (Windows NT or 95/98),
which is powered off in advance.
3. Do software (driver) installation, detailed in the next chapter.
This is to specify the desired I/O address, IRQ and INT Vector in the software
configuration panel, no matter what hardware settings are on the board. The
software configuration program will automatically update the hardware settings.
After this, users already complete the whole installation.
4. Shutdown the system (Windows NT or 95/98).
5. Do power off and then on (or Reset) the PC. (Please cold start.)
6. Restart System (Windows NT or 95/98).
It is very important to keep the JP1 always short in this case. Without running the
hardware configuration program, Io-irq.exe under DOS prompt, the software
configuration program will automatically update the hardware settings of the
board while updating the software settings. This saves the trouble doing hardware
configuration. However, remember to
cold start the system every time the
configuration changed
.