Filter
Top Products
Industio CI-134 Series User’s Manual 2-1
2
2
2
Hardware Installation
The installation of the Industio CI-134 Series consists of hardware and software
installation. The hardware installation is detailed in this chapter. The next chapter
deals with the software installation for various operating systems.
First Thing to Do: Interface Settings
1. Before installing the board into the slot, you should set all the jumpers and
switches to what you want.
The default (factory) settings are set to RS-485,
Auto Data Direction Control mode, indicated as *
.
l CAP Jumper JP1:
Open * Not forcing the CAP address to 0xA700.
Short Force the CAP address to 0xA700. Set to this if you want to do
quick hardware installation.
Or forget the CAP address when
you want to re-configure the board with IO-IRQ.
Termination Resistor Jumper for Port 1
Industio CI-134 Series Board
Data Mode Switch
ON
ON
1 2 3 4
CAP Jumper
JP1
ON
JP3
JP4
JP6
JP5
Interface Switch
Termination Resistor Jumper for Port 2
Termination Resistor Jumper for Port 4
Termination Resistor Jumper for Port 3
1 2 3 4