Husky Baby Carrier Baby Carrier User Manual


 
1312
Installation
5
Verify that the vehicle belt is not
twisted, then buckle (
Fig. D
)
.
6 While kneeling on the restraint to push
it firmly into the vehicle backrest, remove
all slack from the vehicle belt.
First remove slack from the lap portion of
the vehicle belt, then the shoulder portion
(Fig. E & F).
7 Verify that the vehicle belt is tight and
the child restraint is secure.
Refer to
Figure G
for correct routing of the
lap-shoulder vehicle belt.
IMPORTANT:
Always use the Versa-
Tether for children weighing more than
50 pounds (22.6 kg). See pages 18-19.
Removal
Reverse installation procedure.
E
F
Upper Anchorage Points
G
Installation
Lap-Shoulder Belt Installation
Long Route
Figure A
illustrates a typical long route lap-
shoulder belt installation.
WARNING:
Do not install this restraint using a non-
locking ELR vehicle belt, unless a locking
clip is used. Refer to the vehicle owner's
manual for instructions on correct use of
vehicle belts with child restraints.
1 Insert recline bar into holes on rear of
restraint
(
see page 20
)
.
2 Place the child restraint in a forward
facing position on the vehicle seat.
3
Pull the vehicle belt out and pass it
through the first belt slot, from the front of
the restraint to the rear (
Fig B
).
4
Route the vehicle belt around the
back of the restraint then through the
second belt slot, from the rear of the
restraint to the front
(
Fig. C
)
.
B
A
C
D
P2219_R03.qxd 8/18/2004 11:04 AM Page 14