Husky Baby Carrier Baby Carrier User Manual


 
10 11
Installation
LATCH Installation
Figure A
illustrates a typical LATCH
installation.
1
Verify that your vehicle is equipped
with LATCH anchors.
If LATCH anchors are not
installed,
you must use standard vehicle belt
installation methods.
2 Insert recline bar into holes on
rear of restraint
(
see page 20
)
.
3 If stored, remove LATCH
connectors from storage pouches
on rear of cover.
4 Place the restraint on the vehicle
seat with the back facing toward you.
5 Route the furthest LATCH
connector under the recline bar, then
attach to LATCH anchor (
Fig. B
).
A positive click confirms attachment.
Verify that LATCH harness is not
twisted.
6 Rotate seat into forward facing
position.
7 Route the closest LATCH
connector under the recline bar, then
attach to LATCH anchor (
Fig. C
).
A positive click confirms attachment.
Verify that LATCH harness is not
twisted.
8 Push firmly into the vehicle
backrest, then kneel on seat while
reaching through belt slots to
access loop end of LATCH harness
adjuster straps. Pull straps under
recline bar and through slots to
tighten (
Fig. D
). Pull strap until all
slack is removed from the LATCH
harness.
Installation can be improved by the use of the Versa-Tether
®
(
see
pages 18–19
).
WARNING:
Use vehicle belt (not LATCH connectors) for
installations with children weighing more than 48 pounds (21
kg). Refer to the vehicle owner’s manual or contact the vehicle
manufacturer for the maximum weight rating for their LATCH
anchors. Unless specified otherwise by the vehicle manufacturer,
assume a 48-pound child is the vehicle LATCH anchor limit.
Removal
To remove the child restraint, release both LATCH connectors from the
LATCH anchors by pressing the red release buttons. If connected,
disconnect the Versa-Tether from the tether anchor. Store LATCH
connectors and tether components in storage pouches on back of
cover when not in use.
A
B
D
Installation
C
P2219_R03.qxd 8/18/2004 11:04 AM Page 12