Filter
Top Products
1716
Installation
Installation
Lap Belt Installation
Short Route
Figure A
illustrates a typical short route lap
belt installation.
WARNING:
•
Always use recline bar when installing
restraint in vehicle using short route with
vehicle lap belt.
•
Do not install this restraint using a
non-locking ELR vehicle belt, unless a
belt shortening clip is used. Refer to the
vehicle owner's manual for instructions
on correct use of vehicle belts with child
restraints.
1 Insert recline bar into holes on rear of
restraint (see page 20).
2 Place the child restraint in a forward
facing position on the vehicle seat.
3
Pull the vehicle belt out, then pass it through
the first belt slot, from the rear of the restraint
to the front
(
Fig. B
)
.
4
Route the vehicle belt under the cover
then through the second belt slot,
from the front of the restraint to the
rear
(
Fig. C
)
.
B
A
C
5
Verify that the vehicle belt is not
twisted, then buckle (
Fig. D
)
.
6 While kneeling on the restraint to push
it firmly into the vehicle backrest,
remove all slack from the vehicle belt.
7 Verify that the vehicle belt is tight and
the child restraint is secure (
Fig. E
).
Installation can be improved by the use of
the Versa-Tether
®
(
see pages 18–19
).
IMPORTANT:
•
Always use the Versa-Tether for
children weighing more than 50
pounds (22.6 kg).
Removal
Reverse installation procedure.
D
E
P2219_R03.qxd 8/18/2004 11:05 AM Page 18