Filter
Top Products
Do not use this car seat until you read and understand these instructions!
Incorrect usage can mean serious injury or death to a child in a sudden stop or accident!
If you need help, please call 1-800-837-4044
* Remove Current Harness Straps:
* Install New Harness Straps:
1 With both harness straps towards car seat
and short strap towards you:
. Insert anchor into slot in bottom of
shield exactly as shown.
. Pull harness strap to check that
anchor does not come out.
1 Loosen harness straps:
. Lift Adjuster Lever on lower front of
car seat.
. Pull harness straps.
2 Buckle latch tongue into opening. -
2 Remove harness strap loops
from Splitter Plate.
Loops
Splitter Plate
3 Thread right harness strap through
right side of harness tie (child's right).
3 Pull harness straps out of current slots.
4 Remove harness tie from harness
straps.
4 Thread harness straps through desired
slots of seat pad and car seat shell.
IMPORTANT:
. For rear-facing infants, bottom or
middle slots, which are at or just below
shoulders, must be used.
. For forward-facing toddlers, top
slots must be used.
5 Push red button on lower front
of car seat to unbuckle latch tongue.
5 Slide loop on end of each harness
strap onto Splitter Plate.
Red Button
Shield
\
6 Cut harness strap close to shield.
NOTE: Do not attempt to remove
metal anchor inside shield. Loose
metal anchor may remain inside --po
shield. ;
Cut Here
Close To Shield
6 Make sure Splitter Plate Strap
passes between recliner stand and
car seat shell (see arrow).
NOTE: Splitter Plate Strap must
not be twisted.
~
'I
~I
Throw harness strap away.
Splitter Plate Strap
~
~
01
ENGLISH PM-O548AA 4197