Filter
Top Products
Ekho - E- 10
Heart Rate Monitor
1. Functions
Heart Rate Functions:
Current Heart Rate
ECG Accurate
Watch Functions:
Time of Day
Other:
Large Dual Display
Easy to Start
Water Resistant
Comfortable Ultra-Slim Ergonomic Chest
Belt Transmitter w/ user Changeable Batteries
Interfaces with Heart Rate Interactive Exercise
Equipment at home and in the gym
2. Putting on your Ekho Heart Rate Monitor
Receiver:
Mount the Receiver on either your left or right wrist.
The watch receives and translates the electrical
signals generated by your heart via the transmitter.
Transmitter Belt:
Attach the transmitter to the elastic strap.
Wrap the transmitter around your chest and adjust
the length of the strap so it fits snug.
The strap should be comfortable and secure.
(If the strap is not secure, the electrodes may lose
contact or the transmitter may slide down during
exercise.)
The transmitter should be positioned just below the
breasts/pectoral muscles, with the transmitter
centered on the chest.
Wet the electrodes (rubber pads), the
electrodes must be wet for accurate heart rate.
The transmitter will automatically turn on when the
above actions are done.
The optimal distance from the receiver (watch) to the
transmitter is 1 meter (3.28 feet).
Note: All telemetry pulse watches are subject to interference
from strong electromagnetic fields generated from motors, TV
sets, computers, high voltage power cables which can disrupt
the reception and cause incorrect hear rate measurements.
3. Setting Time
Press “Select” and hold for 3 seconds. 12/24 hour will flash.
When 12/24 hour begins to flash, press “Select” to select
mode.
When finished wait 7 seconds and hours will begin to flash.
Press “Select” until hour desired is flashing. Wait 7 seconds.
Repeat this process with Minutes and Seconds.
Once complete wait 7 seconds and clock will begin.
4. Now It’s Time to Begin
Press “Select”, a zero will appear in the lower portion of the
Display. Once a signal from the transmitter is detected, the
heart symbol will begin to flash in conjunction with your
heartbeat. Your heart rate will display in a few seconds.
If the heart symbol does not flash, the signal is not being
received. Check the position of the transmitter. Verify the
electrodes are moistened.
5. Now It’s Time to Begin
Press “Mode”, until a zero will appear in the lower portion of
the Display. Once a signal from the transmitter is detected,
the heart symbol will begin to flash in conjunction with your
heartbeat. Your heart rate will display in a few seconds.
If the heart symbol does not flash, the signal is not being
received. Check the position of the transmitter. Verify the
electrodes are moistened.
6. Your done exercising.
Wash Transmitter belt with soapy water then rinse.
Dry Transmitter with soft cloth.
Store Transmitter a place that is clean and dry. Dirt and
moisture may cause transmitter to continue reading, reducing
the life of the battery.
7. Haven’t exercised in a while?
Ekho Heart Rate Monitors is to be used to display heart rate
during exercise only and cannot predict the intensity level that
is safe for you. It is not intended for medical diagnostic
purposes or for prevention of heart related health problems.
Before you begin any exercise program, please consult your
physician:
a. If you have been inactive for a period of time
b. Have a history of cardiac illness
c. Smoke
d. Have high blood pressure
e. Are over-weight.
If you use a pacemaker, do not use a heart monitor until you
consult your doctor.
8. Ekho Specifications
Receiver:
Heart Rate Range 30 to 240 BPM
Heart Rate Accuracy +/- 1 BPM
Operating Temperature 0 C-50 C (32 F – xx F)
Storage Temperature -20 C – 80 C (xxF-xxF)
Battery 3 volt Lithium 2032 cell
Weight 30.6 grams
Transmitter & Belt:
Emitted Frequency 5KHz +/- 10%
Battery 3 volt lithium 2032 cell
Weight 4 oz.
9. Limited Warranty
Warranty, Terms and Conditions
If the product becomes defective during the 2-year Limited
Warranty period Ekho will repair or
replace any defective component part at no charge to the
original owner, subject to the limitations
and requirements listed.
THE FOLLOWING IS REQUIRED BY EKHO when requesting
warranty services:
Check your resellers return policy. All purchased products
must be returned to original place of
purchase within their return policy time period.
The product must be packed in the original shipping carton or
in a suitable packing offering
similar degree of protection. To avoid scratches or other
damages to the product during shipping
separate items, such as HRM, transmitter belt, transmitter,
should be individually wrapped and
placed in the same package. This will reduce any extra cost of
return freight/postage. Please
include a copy of Proof of Purchase and/or copy of registration
form.
Limitations: The limited warranty provided by Ekho does not
cover: A: Batteries. B: Damages
due to misuse. C: Abuse or accidents. D: Cracked or broken
cases. E: Negligence of Precautions. F: Improper
maintenance or commercial use. D: Repairs made by a non-
Authorized technician. The warranties contained herein are
expressly in lieu of any other warranties including implied
warranty of merchantability and/or fitness for purpose. In no
event
Shall Ekho be liable for arising out of or related to the use of
this manual or the products
Described herein.
10. Disclaimer
The material in this manual is for informational purposes only.
The products it describes are subject to change without prior
notice, due to the manufacturer’s continuous development
program.
Ekho makes no representations or warranties with respect to
this manual or with respect to the products described herein.
Ekho shall not be liable for any damages, direct or incidental,
consequential or special, arising out of, or related to the use of
this material or the products described herein.
EKHO Brand Americas, LLC
1624 Harmon Place Suite 207
Minneapolis, Minnesota 55403
001-612-922-3766
001-612-922-3767
www.ekho.us