Filter
Top Products
43
42
The top anchorage strap (tether) is used for the forward-
facing position only.
Most vehicles made after 9/1/99 already have the anchor
hardware for a top anchorage strap. Refer to your
owner’s manual or call your dealer.
Storage of Top Anchorage Strap:
Rear-Facing position: Place top anchorage
strap over the back of the child restraint with
the anchor hook secured under the child
restraint.
Belt-Positioning Booster position: Place
top anchorage strap behind the seat with the
anchor hook under the seat.
Adjusting the Top Anchorage
Strap
Pull loose
end to
tighten
Lift up to
loosen
To Attach Top
Anchorage Strap:
Put knee in child
restraint and push down;
attach hook to anchor in
vehicle.
To Adjust Top
Anchorage Strap:
To tighten; pull on free
end of top anchorage
strap.
To loosen; lift up on top
anchorage lock and push
lock toward top
anchorage hook.
Belt-Positioning Booster Use: 40-80 lbs. (18.1-36.3 kg), 43-52” (110.1-132.1 cm), Over 1 year of age.
Belt-Positioning Booster Use
Lap/Shoulder Belt
Refer to the “Choosing
Restraint and Position”
section to make sure
your child is at the
proper weight and
height to use the belt-
positioning booster.
WARNING
!
A loose LATCH system can result in
serious injury or death.
Do not use LATCH
when using the belt-
positioning booster.
You MUST fasten the
LATCH belt hooks on
side of child restraint as
shown.
When your child is over
40 lbs. (18.1 kg) or 43”
(110.1 cm) and over 1
year old, you must
remove the harness and
use this seat as a belt-
positioning booster.
4358-3432E Enspira 5pt 8/6/07 4:46 PM Page 45