Eddie Bauer 22859 Car Seat User Manual


 
NOTE:
If your vehicle does not have an anchor
bracket, tuck the top anchorage strap’s hook under
the child restraint.
27
Forward-Facing Installation with
Vehicle Belts:
1
2
3
Place child restraint flush
against the back of the
vehicle seat forward-
facing in the back seat.
Thread the vehicle lap
belt or lap/shoulder belt
combination through the
belt path and out other
side. Buckle.
Place one knee in the
child restraint and push
down firmly while pulling
up on belt to tighten. For
a manual belt, refer to
“Knowing your Vehicle
Belt” section.
With weakest hand at
belt path, tilt and push
the child restraint
forward and back, and
from side to side. If the
seat belts do not loosen,
your child restraint
should be secure.
NOTE: Some “play”
from front to back or
about an inch from side
to side is acceptable. If it
moves more, review
“Knowing Your Vehicle
Belts” and “The Locking
Clip” sections.
4
WARNING
!
After checking for hot
seat and buckles, place
your child in the child
restraint as described in
the “Securing Your Child
in the Child Restraint”
section.
5
Using this child restraint in any vehicle
seat where the lap belt cannot be
tightened securely and properly or where
it can be loosened by pulling on it can
result in serious injury or death.
Forward-Facing Use: 22-40 lbs. (10.1-18 kg), 34-43” (85.1-110 cm), Over 1 year of age.
26
With knee still in child
restraint, attach hook to
anchor in vehicle. Push
down firmly and tighten
top anchorage strap.
To adjust top anchorage
strap: See “Adjusting Top
Anchorage Strap”
section.