Filter
Top Products
K
L
N
O
Q
S
1
6 ”
A (SS-30)
C (SS-30)
C (SS-30)
2
2X
N
3
5
ASSEMBLY INSTRUCTIONS
1. USING HARDWARE FROM THE SS-30 GATE,
install hinge bracket (A) to wall using Phillips
screw (C) beginning 6 ” above floor surface.
Install second screw (C) in top of hinge bracket
securing it to the wall.
(Use ruler on left edge of this sheet to measure
from floor)
2. Insert eye bolts with standard nut and washer
(N) into top and bottom of the first 21 ” BX2
extension.
3. Hang first BX2 extension by inserting hinge rod
(L), through top of mounted hinge bracket (A),
through upper plastic shoulder washer (O),
through both eye bolts, through lower plastic
shoulder washer (O), and finally through bottom
of hinge bracket. To secure hinge, insert key
ring (S) through hole in end of hinge rod.
4. Connect BX2 extensions together by using three
(3) 1 ” hex head bolts and washer using
hardware from BX2 (M) to join.
5. Mount hinge bracket (K) to end of final BX2
extension using 1 ” hex head bolts, washer and
lock nuts (P). Attach the T-Bar (T) support to
the bottom of the BX2 extension when inserting
lower hex bolt.
GATE IS RECOMMENDED FOR CHILDREN BETWEEEN 6 AND 24 MONTHS.
MODEL EX-5
T-BAR FLOOR MOUNT:
To give added stability,
secure gate to floor with
either 2” screws (Q) through
holes in bottom of T-Bar or
attach enclosed Velcro strips
(R).
OPTION
EXTENSION KIT TO ACCOMPANY MODEL SS-30
ALL PARTS IN STEP ONE COME FROM MODEL SS-30 HARDWARE
M
P
L
O
S
4
3X
M
P
2X
K
IMPORTANT: CARDINAL GATES RECOMMENDS USING
ONE (1) T-BAR SUPPORT BRACKET FOR EVERY
(2) TWO BX2 EXTENSIONS.
R
OPTION
6
6. Now move to SS-30 instruction sheet and mount
the Stairway Special gate to hinge bracket (K)
that was mounted in STEP FIVE.
Mount SS-30
T
T