Filter
Top Products
A
B
C
E
F
G
J
I
1
6 ”
A
C or J
2
C or J
3
2X
E
4
B
F
I
5
LOOSEN AT TOP AND
BOTTOM OF GATE TO
ADJUST GATE WIDTH
2X
G
6
K
H
ONE-WAY
STOP BRACKET
OPTION
ASSEMBLY INSTRUCTIONS
2. Install second
screw (C) in
top of hinge
bracket
securing it to
the wall.
NOTE: THIS SIDE OF GATE HAS
THREE (3) HOLES - ONLY USE TOP AND
BOTTOM HOLES FOR THIS STEP
3. Insert eye bolts with nut and washer (E)
into top and bottom of hinge side gate
(side with three holes). Be sure nuts are
tight. Do not use middle hole for this step.
4. Hang gate by inserting hinge rod (B), through top
of mounted hinge bracket (A), through upper plastic
shoulder washer (F), through both eye bolts, through
lower plastic shoulder washer (F), and finally through
bottom of hinge bracket. To secure hinge, insert
key ring (I) through hole in end of hinge rod.
5. Use Allen wrench (G) to unscrew
set screws on top and bottom of
gate to extend gate. LEAVE
SHIPPING TABS IN PLACE NOT TO
MAR GATE FINISH. You will remove
shipping tabs during final tightening.
6. Mount latch assembly (K) to gate using 3/4” bolts with serrated
washers (D). Attach wall mount for latch assembly (H) up
into part (K) that is now secure on gate. Slide gate out to
mark holes for (K) on attaching wall. (*OPTIONAL ONE WAY
BRACKET INSTALLED HERE) Then attach the wall mount of
latch assembly to wall using Phillips head screws (C).
GATE IS RECOMMENDED FOR CHILDREN UP TO 24 MONTHS.
CLEAR GATE - MODEL CP30
D
H
K
L
ONE-WAY
STOP BRACKET
OPTION
D
D
ONE-WAY
STOP BRACKET
OPTION
L
IF GATE IS INSTALLED AT TOP OF STAIRCASE:
Install one-way stop bracket (L) on one side of
wall mount latch if you wish to have gate open in
only one direction.
FOR OPENINGS 26.5” (67cm) - 41.5” (105cm)
SEE REVERSE
FOR GATE
OPERATION
INSTRUCTIONS
1. Install hinge bracket
(A) to wall (stationary
side of gate) using
Phillips screw (C)
beginning 6 ” above
floor surface. (Use
ruler on left edge of
this sheet to measure
from floor).
OPTION: Long
screws (J) maybe be
used to attach gate to
stud through dry wall.