Filter
Top Products
Congratulations on your purchase of the BOB Handlebar Console. It
is designed to provide beverage holders and additional storage. Proper
installation and care will provide years of reliable service.
Before attempting to install your new Handlebar Console, read
and understand these instructions completely to insure proper
installation. If you are unclear on any point, contact your dealer or
BOB before use.
WARNINGS
.
.
This product is not designed to hold hot beverages. Placing
hot beverages in the cup holders can result in spills and injury
to you or your child, including burns.
.
.
When placing containers in the cup holders, it is critical that
at least 60% of the container be inserted in the beverage holder
so containers do not come out.
.
.
The Handlebar Console is designed exclusively for use with
BOB single strollers. It is not intended for use with other
strollers or products.
INSTALLATION
1. Begin by orienting the Handlebar Console as shown in figure 1.
2. The Handlebar Console
attaches to the stroller
handlebar by 4 velcro straps.
Start attaching the Handlebar
Console to the handle bar with
the forward right velcro strap,
A in figure 1. The strap
attaches as follows:
A) Align the strap with the
forward edge of the handlebar
foam. Route the strap
underneath the handlebar and
between the black metal rod,
brake cable housing and
handlebar being careful not
to wrap the strap around the
red handlebar release lever.
Note: older strollers do not
have a black metal rod or red
handlebar release lever.
WARNINGS - It is critical
that the strap not wrap
around the black rod, brake
cable housing or red
handlebar release lever. Wrapping the strap around the black
rod can interfere with the correct function of the handlebar release
system resulting in the handlebar unexpectedly releasing, causing
loss of control and injury.
Wrapping the strap around the brake cable housing can interfere
with the proper function of the brake causing loss of control and
injury.
Wrapping the strap around the red handlebar release lever can
interfere with the correct function of the handlebar release system
resulting in the handlebar unexpectedly releasing, causing loss
of control and injury.
Correct routing of the velcro
strap is shown in figure 2.
B) Continue wrapping the
velcro strap around the
handlebar and insert through
the black plastic ring as shown
in figure 3.
C) Loop the velcro strap
through the ring and secure
as shown in figure 4.
D) Repeat with the above
steps with the forward strap
on the opposite side.
3. Next attach the back right
strap, B in figure 1. The strap
attaches as follows:
A) Align the strap so the
Handlebar Console is pulled
tight fore and aft. Route the
strap underneath the
handlebar and between the
brake cable housing and
handlebar.
WARNING - It is critical
that the strap not wrap
around the brake cable
housing. Wrapping the
strap around the brake
cable housing can interfere
with the proper function of
the brake causing loss of
control and injury.
Correct routing of the strap is
shown in figure 5.
B) Continue wrapping the
velcro strap around the
handlebar and insert through
the black plastic ring as shown
in figure 3.
C) Loop the velcro strap through the ring and secure as shown in
figure 4.
D) Repeat with the above steps with the rear strap on the opposite
side.
CARE INSTRUCTIONS
Hand wash cold, hang dry, do not dry clean or iron.
LIMITED WARRANTY
BOB Trailers Inc. takes pride in its workmanship and strives to
manufacture the best products possible. Therefore, we warranty the
Handlebar Console against defects in material and workmanship
subject to the conditions listed below. Since no product is indestructible,
it does not cover defects attributable to or resulting from normal wear,
abuse or alteration.
.
The Handlebar Console is warranted for one year from the date of
original purchase.
.
Warranty is only valid for the original purchaser.
.
Proof of purchase is required to exercise this warranty.
.
Labor and freight charges are not included.
.
Normal wear, neglect, abuse, accidents, improper use are not
covered by this warranty.
.
Warranty claims must be made through an authorized dealer.
.
This warranty is limited to the repair or replacement of the defective
part. BOB shall in no event be responsible for consequential or
special damages.
.
This limited warranty is the only express or implied warranty
applicable to BOB. Any implied warranties, including warranties
of merchantability and fitness shall be limited in scope and duration
in accordance with this limited warranty.
Fig. 3 Velcro strap routing
Velcro Strap
Around Handlebar
Velcro Strap
Looped Through
Plastic Ring
Fig. 1 Console orientation
Black Rod
Velcro Strap
Routed Above
Black Rod
Red
Handlebar
Release
Lever
Fig. 2 Vecro strap routing
Fig. 4 Velcro strap secured
Velcro Strap
Routed Above
Brake Cable Housing
Brake Cable
Housing
Fig. 5 Velcro strap routed over
brake cable housing
Handleb
Handleb
ar c
ar c
onsole ins
onsole ins
tr
tr
uctions
uctions
(800) 893-2447 www.bobgear.com email- info@bobgear.com
Phone: (208) 375-5171 Fax: (208) 375-5172, 5475 Gage St. Boise, I
D 83706
OMA01B