Audiovox 5BLCR Automobile Accessories User Manual


 
128-6690
1 of 8
Model 5BLCR &
5BLCRA
Programming Guide
The 5BLCR is designed to work with most Audiovox two way remote start unit
and may be programmed differently for other models. For the APS-55TW, the
recommended transceiver programming is shown below.
Note: A total of 4 transmitters may be programmed into any receiver channel.
1 Lock
2 Unlock
3 Remote Start/Stop
4 Option
The 5BLCRA is designed to work with most Audiovox two way alarm sys-
tems and may be programmed differently for other models. For the APS-590,
the recommended transceiver programming is shown below.
1 Lock
2 Unlock
3 Trunk Release (Optional)
4 Option
The intent of the Option button is to facilitate operation of other Audiovox RF
devices such as a second vehicle or a Garage Door Interface unit.
In the case of the APS-590, there is also an additional output on the control
module in the vehicle which may be programmed to operate from the Opt.
Button. Please check with your installation center for the programming of your
unit.
A total of 4 transmitters may be programmed into any receiver channel.
Force programming a transmitter, removing a transmitter, or reprioritizing a
transmitter is covered later in this manual.
Also, if you do not program a transmitter button into channel 2 which is the
separate unlock/disarm channel, then whatever button is programmed into
channel 1 will serve as both lock/arm & unlock/disarm.
Note: The “F” Button serves as a function button in combination with other
buttons explained in your owners manual. This button may not be used to
operate a receiver channel.
Note: Alarm units have a sounding device, siren or horn, keyless entry units
may or may not include a sounding device. Where mentioned, you may or may
not hear a chirp from the siren or horn. In the case of a keyless entry unit,
when entering a code, the unit will flash the parking lights to indicate the code
is learned.