ATD-8699
MASTER BALL JOINT SET
WARNING: TO HELP PREVENT PERSONAL INJURY
z Always wear ANSI approved goggles when using this product. Normal use of this product is likely to expose the
user to dust and/or microscopic particles containing chemicals known to the State of California to cause cancer,
birth defects or other reproductive harm. Always wear appropriates safety equipment and clothing when using this
product.
z Study, understand, and follow all instructions provided with this product.
z Before repairing vehicle, block the wheels to prevent the vehicle from moving.
z Check the final alignment of the C-frame press and all tooling with components before exerting pressure to remove
or replace a ball joint.
OPERATING INSTRUCTIONS
Brake Anchor Pin Removal and Installation
1. Remove all lock ring retainers from the brake anchor pins.
2. Position the C-frame press over the brake spider as shown in Figure 1.
3. Tighten the forcing screw until the anchor pin is removed.
U-Joint Assembly and Disassembly
The basic C-frame press is used to service the U-Joints on most cars and light trucks.
The U-Joints can be serviced either on or off the vehicle.
Disassembly
1. Remove any external and/or internal lock rings.
